- Can you bring the vehicle inspection memory aid with?
- What 3 kinds of emergency equipment must you have?
- How long should a post trip inspection take?
- Why should you put the starter switch key in your pocket?
- What are some things you should check on the front of your vehicle when doing the walk around inspection?
- How long is a pre trip inspection valid for?
- Is it bad to roll backwards in Drive?
- How do I know if my starter relay is bad?
- Can you bypass a starter relay?
- What is the most important reason for doing a pre trip inspection?
- How can you start moving without rolling backwards?
- Can a starter relay be intermittent?
- How do I know if my starter solenoid is bad?
- How do you not roll back on a hill in a manual?
Can you bring the vehicle inspection memory aid with?
Can you bring the “vehicle inspection memory aid” with you to the test.
You either know it or you don’t..
What 3 kinds of emergency equipment must you have?
What three kinds of emergency equipment must you have? Spare electrical fuses, three red reflective triangles, properly charged and rated fire extinguisher.
How long should a post trip inspection take?
approximately 30 to 50 minutesIf you check everything you should be checking, a full inspection should take you approximately 30 to 50 minutes. The key to a good inspection is to take your time while working your way systematically around each section of your vehicle and performing each check fully.
Why should you put the starter switch key in your pocket?
Why should drivers put the starter switch key in your pocket during the pre-trip inspection? To prevent injury from a running motor or other moving parts. To prevent vehicle theft while you are not in the cab. To prevent the trailer from coming loose and rolling down an incline.
What are some things you should check on the front of your vehicle when doing the walk around inspection?
Name some things you should check on the front of your vehicle during the walk-around inspection.Go to front of vehicle and check that low beams are on and both of the 4-way flashers are working.Push dimmer switch and check that high beams work.Turn off headlights and 4-way, hazard warning flashers.More items…•
How long is a pre trip inspection valid for?
24 hoursIs valid for 24 hours from the time recorded in a trip inspection; • Must be forwarded to the driver’s home terminal within 20 days; • Must be filed at the carrier’s principal place of business within Alberta within 30 days; • Must be maintained for at least 6 months.
Is it bad to roll backwards in Drive?
As a rule of thumb you should always come to a FULL stop before changing your vehicles direction or going into park. Over time you could be going just a little too fast and shock the transmission which could cause compounding damage over time.
How do I know if my starter relay is bad?
How To Tell If Starter Relay Is Bad?The Vehicle Is Dead. The most obvious symptom is a completely silent car that does not respond when you turn the ignition key. … Starter Making Clicking Sounds. It happens when the relay cannot send a full signal. … Occasional Failures In Starting The Vehicle. … Starter Does Not Get Switched Off.
Can you bypass a starter relay?
Place the metal blade of an insulated screwdriver across both metal contacts. This bypasses the solenoid and creates a direct connection between the starter motor and the ignition switch.
What is the most important reason for doing a pre trip inspection?
The most important reason to perform a pre-trip inspection is for your safety. It can be dangerous to go out on the road with a load that is not secured, brakes that are damaged, wiring that is not connected, etc.
How can you start moving without rolling backwards?
If stopped on a hill, how can you start moving without rolling back? partly engage the clutch before you take your right foot off the brake. Release the parking brake with enough engine power. the hand valve can be applied to keep from rolling back.
Can a starter relay be intermittent?
Intermittent issues starting the vehicle If the starter relay is working properly, it will send power to the starter every time it is engaged. However, it is possible that the starter relay will become damaged due to excessive heat, dirt, and debris or other issues that might cause sporadic operation of the starter.
How do I know if my starter solenoid is bad?
Take note of these three common symptoms of a bad solenoid:Vehicle won’t start.Starter solenoid fails to reset even after switching the car off.Bad starter solenoid sound (successive clicking or grinding sound)
How do you not roll back on a hill in a manual?
How to Drive Manual Car Uphill without Rolling Back?Stop completely. Imagine a situation when you are driving your car up a hill and has to stop at a traffic light just before the intersection at the top of the incline. … Shift the gear. … Release the clutch. … Let go of the handbrake. … Disengage the clutch.